49
Operating Manual ULTRA DUO PLUS 80
ENTER
Hold the ENTER button
pressed in for 2 sec. to
start the charge process.
[ LiPo ] CHARGE
*** BATTERY ***
*** CHECK ***
C-TCS: 15% 0:00:12
CAPACITY : 10mAh
VOLTAGE : 7.612V
CURRENT : 2.20A
C-TCS: 15% 0:01:25
INPUT VOLT : 14.222V
PEAK VOLT : 7.612V
AVG. VOLT : 0.000V
Mode
ESC
C-TCS: 15% 0:02:59
BAT. TEMP. : 22.1°C
PEAK TEMP. : 22.1°C
BATTERY RES: 30m
Ω
Mode
ESC
2S= 7.687V 1S=3.845V
13.84V
13.84V
5mV
2
1
Mode
ESC
1
Press the ‘Inc’ or
‘Dec’ button to
display the
appropriate line.
ESC
END
CHARGE
Hold the ENTER
button pressed in
for 2 sec. to stop
the charge process
11] LiPo 3S 2200mAh
STORE MODE START
CHG.
:
2.1A
4.20V/C
DCHG. : 10.0A 3.0V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
0 ] NiMH 6S 3300mAh
CYCLE : C->D 1x 10m
CHG. : 3.3A 5mV/C
DCHG. : 5.0A 0.8V/C
15. Charging / discharging LiXX batteries
Before starting a process please ensure that all parameters are set correctly to match your battery type, and that the battery is connected correctly to the
charge output and the balancer. Use the INC or DEC button to move the Select arrow to the appropriate line: storage charge (STORE MODE START),
charge (CHG) or discharge (DCHG). With a brief press on the ENTER button you can run through all the parameters of the selected mode once more,
and adjust them if necessary. Start the process by holding the ENTER button pressed in for two seconds.
If you wish to alter the charge current during the charge process, press the ENTER button briefly: the charge current is highlighted, and can be adjusted
using the INC or DEC button.
Pressing the MODE or ESC button switches between the various charge displays. If you wish to halt the charge process, hold the ESC button pressed
in for two seconds.
