GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. 06/2010
4
As ON / OFF switch for the receiving system we strongly recommend the use of the
PRX, Order No. 4136.
You will need four suppressor filters, Order No. 1040, or a folding ferrite ring, Order
No. 98516.1 and four extension leads, Order No. 3935.18, in order to connect the
two aileron servos and two landing flap servos to the receiver, i.e. these leads are
plugged into the receiver permanently.
The following servo leads are required: one extension lead, Order No. 3935.65, for
each aileron servo, and one extension lead, Order No. 3935.32 for each landing flap
servo. The receiver and receiver batteries should be packed in soft foam for shock
protection.
The model requires standard-sized servos with an output torque of around 50 Ncm.
Adhesives
Fast-setting epoxy, e.g. UHU plus schnellfest, Order No. 962
Slow-setting epoxy, e.g. UHU plus endfest 300, Order No. 950.43
Wood glue, e.g. UHU Holzleim express, Order No. 958.60
UHU hart, e.g. Order No. 534.35
Cyano-acrylate, e.g. Order No. 5821
Cyano-acrylate, e.g. Order No. 5822
Thread-lock fluid, e.g. Order No. 952
Items required for flying the model
(not included)
Fuel based on synthetic oil, to suit engine
Fuel filter, e.g. Order No. 1650.1
Fuel tubing, e.g. Order No. 1643 for glowplug engines
Fuel tubing, e.g. Order No. 1325.2 for petrol engines
Aerobatic fueltank, e.g. Order No. 136
Fueltank plugs, Order No. 133
Manual fuelpump, e.g. Order No. 1610 or 6870
Glowplug energizer battery with plug clip, e.g. Order No. 3247
Electric starter, e.g. Order No. 1628
Starter battery, e.g. Order No. 2592
Tools required
(not included)
Set of cross-point screwdrivers, pointed-nose pliers, flat-nose pliers, side-cutters,
balsa knife or razor blade, set of twist drills, pencil, felt-tip pen, fine-tip soldering iron.
Assembling the
PIPER CHEROKEE
Wing and undercarriage
Please don’t start assembling the model until you have checked the kit components
and the building instructions, and are familiar with the construction procedure. If you
are not happy with any component, kindly return it to your model shop without delay.
