GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. 06/2010
12
Screw an M2 locknut onto the threaded end of the elevator pushrod, followed by a
clevis. Screw the clevis in or out until the elevator is exactly at centre when the servo
is at neutral. Adjust the pull-cable (closed loop) rudder system so that the rudder and
servo are exactly at centre, and both cables are under equal and moderate tension,
i.e. there is no lost motion (slop) in the control system.
The two pilots’ seats, the joysticks, the dummy baggage and the sunshield have to be
installed in the cockpit before the canopy is attached to the fuselage, as shown in the
photos below.
Cut out the sunshield along the marked lines, and fix it over the control panel as
shown in the right-hand photo. This is most easily accomplished using strips of clear
adhesive tape.
The dummy baggage can simply be glued in the appropriate position using UHU
ALLESKLEBER Kraft.
