Micro Star 400 v2
18
Slide one of the two collets on the main rotor shaft, and fit the whole assembly through the ball-
races in the chassis from above, and through the main gear. Fit the second collet on the bottom
end, position it flush with the bottom end of the main rotor shaft, and tighten the retaining screw.
Pull the shaft up as far as it will go, slide the top collet down until it rests on the upper ballrace,
then tighten the retaining screw in the top collet.
Fit the collective pitch pushrod into the clamp of the collective pitch lever, and tighten the
clamping screw. Ensure that full symmetrical control travel is available on both sides of the cen-
tre position of the lever. Connect the swashplate linkages to the swashplate to complete this
section.
Install the motor 4441.21 in the chassis from the underside, and secure it with the retaining
screws. Assemble the skid landing gear from parts 4441.305 and 4441.306, and fix it to the
chassis using the self-tapping screws supplied. Align the skid tubes 4441.306 carefully, then fix
them to the skid bars 4441.305 using small self-tapping screws or cyano.
Summary of Contents for Micro Star 400
Page 28: ...Micro Star 400 v2 4 Notes...
