Micro Star 400 v2
10
Connect the speed controller to the motor as described in the instructions supplied with it. Keep
the cables as short as possible, and ensure that there is no short-circuit between the pins of the
suppressor capacitors (soldered to the motor terminals) and the motor case.
The flight battery, which also provides power to the receiving system via the BEC circuit
incorporated in the speed controller, is connected to the system by a plug and socket. This
connection should be positioned for easy access even when the cabin is in place, because the
plug and socket serve as the ON / OFF switch for the receiving system, as well as the flight
battery charge socket.
The flight battery is installed at the bottom of the chassis at the front, as shown in the drawing;
ensure that it is pushed fully into place; this will ensure that the Centre of Gravity (directly below
the main rotor shaft) is correct when the cabin is fitted. When you are satisfied, group the cables
together so that the cabin can be fitted without fouling anything.
Summary of Contents for Micro Star 400
Page 28: ...Micro Star 400 v2 4 Notes...
