GRAUPNER Falcon 12, Manual

Page: 43 / 52

43 / 52
S1019_S1034_S1035_33579_33583_FW2_DE_V1.0sh
3. Push or tap on the ENT key.
"NO" is displayed inverted.
4. Change the value field to "YES".
5. Push or tap on the ENT key.
6. At the transmitter briefly bring the roll control stick to the right
stop.
The display shows the roll axis inverted.
7. Tilt the helicopter more than 45 degrees to the right.
As soon as the detected axis with the required sign is displayed in
"normal" representation, the axis assignation is completed.
8. At the transmitter briefly bring the nick control stick to the front
stop.
The display shows the nick axis inverted.
9. Tilt the helicopter more than 45 degrees to the front.
As soon as the detected axis with the required sign is displayed in
"normal" representation, the axis assignation is completed.
10. At the transmitter briefly bring the tail control stick to the right
stop.
11. Turn the helicopter clockwise by more than 45 degrees to the
right.
As soon as the detected axis with the required sign is displayed in
"normal" representation, the axis assignation is completed.
Notes
• The assignment of the axis the pirouette optimization is auto-
matically adjusted.
• If the direction of rotation of the tail servo is later changed for
any reason, the axis assignment must be carried out again.
• If one of the directions of operation is wrong, you must repeat
the axis assignment process.
• As a result of the control, the servos no longer return to their
zero position or move slower. It is not a mistake and it will not
be noticeable in the air, since then the regulation can work
freely.
• If the directions are changed on the transmitter due to any mod-
ifications being made to the helicopter (e.g. new servos) or if the
receiver is installed in a different position, the axis assignment
procedure must be fully repeated.
The gyros and operating directions have now been assigned. For
safety reasons, the effective directions must be checked.