GRAUPNER Falcon 12 plus, Manual

Page: 9 / 34

9 / 34
S1038_Q06_V1.0pn_en
Installing the Graupner S1034 Falcon 12 plus
The
Graupner S1034 Falcon 12 plus
must be mounted with its lower
surface parallel to the chassis using double-side adhesive shock-ab-
sorbing foam tape.
The
Graupner S1034 Falcon 12 plus must be protected against dust,
splash water, etc. in the model. When you install your Falcon 12 plus ,
make sure that it is not excessively airtight to prevent it from over-
heating during operation.
The cables may not be wound around antenna or run next to it. Make
sure that the cables cannot shift to lie directly adjacent to antenna
during flight.
In the case of carbon fibre chassis, at least the last 35 mm of the
antennas shall be routed outside.
Connecting the RC components of the copter
Insert the connection cable of the ESCs of the copter, which must be
connected to the receiver, with the black or brown cable upwards
into the connector strip of the receiver, as shown in the illustration
on the left. The polarity of the plug-in system cannot be reversed. Do
not apply force. The servo connections of the Graupner -HoTT
receiver are numbered. Only use speed controllers that are
multi-
shot capable to connect the motors.
Connection 1: Speed controller for motor 1
Connection 2: Speed controller for motor 2
Connection 3: Speed controller for motor 3
Connection 4: Speed controller for motor 4
Connection 5: PDB S8474 and GPS S8437 or servo or a receiver with
SBUS signal. The SBUS signal is automatically detected after the
power-up of the receiver.
Connection 6: can be used to connect a servo, SUMD signal, SBUS
signal or Smart-Audio compatible FPV video transmitter.
Optional accessories
PDB with SBEC power supply S8474
GPS module S8437