GRASS VALLEY UCP-3901, User Manual

Page: 205 / 210

205
UCP - 3901
User Manual
Essence Processing (EP) Ethernet Media Ports SFP1 & SFP2
Multiviewer (MV) Ethernet Media Ports SFP1 & SFP2
Physical 4 × SFP28 Ethernet cartridge slots.
UCP-3901 25Gb: SFP+ 2 x 25GbE
UCP-3901 50Gb: 2 x 50GbE QSFP, or 1 x QSFP with two lanes of
50GbE
Addressing DHCP (default) or static
Connector/Format See Supported SFP28 Cartridges , on page 16.
Conforms to IEEE 802.3by - 25 Gigabit Ethernet over fiber
IEEE 802.3 - 25 Gigabit Ethernet over twinaxial cables
a
ST2110-10/20/30
SMPTE-291M/IETF RTP Payload for Ancillary Data
VC-2
AES67
IEEE-1588v2/SMPTE-2059-2
a.Note that when using a 50Gbps breakout cable, ensure that the network switch supports this
feature.
FEC The UCP - 3901 supports clause 74 (Base-R) and clause 108 (RS) FEC.
Ensure the network switch you plan to use supports FEC error
correction that you are planning to use for your network.
Video Standards 2160p60, 2160p59, 2160p50 (ST2082-10, mode1 or ST425-5)
1080p60, 1080p59, 1080p50 (SMPTE ST274)
1080i30, 1080i29, 1080i25 (SMPTE ST274)
720p60, 720p59, 720p50 (SMPTE ST296)
625i25, 525i29 (SMPTE ST125)
Latency IP Sender: < 1 line (ignoring compression codec latency)
IP Receiver: N->(N+1) frames*
*This is dependent on the setting N, currently 0/1/2/3, for the
number of frames of delay applied in the packet store buffer. With
N=0, the minimum delay is approximately 32 lines by default.
Physical 4 × SFP28 Ethernet cartridge slots.
UCP-3901 25Gb: SFP+ 2 x 25GbE
UCP-3901 50Gb: 2 x 50GbE QSFP, or 1 x QSFP with two lanes of
50GbE
Addressing DHCP (default) or static