GRASS VALLEY UCP-3901, User Manual

Page: 20 / 210

20
UCP - 3901 Card Installation and Operation
Front Card-edge Interface
Item Description
Ident Button Push to:
• Make the card’s SDI IN LEDs flash.
• Activate the
Configuration
>
Location
>
Where Am I
checkbox in
RollCall.
This works bi-directionally between the card and the RollCall setting.
See also Configuration , on page 48 for more information about the
Where Am I checkbox.
Ejector Tab Lift the bottom edge of the ejector tab to lever and remove the card
out of the frame. See Installation of the Rear Connector Panel and
Card , on page 23.
SDI IN 1 to SDI IN
16 status LEDs
As an input, this shows the following port status:
• Green: Signal is detected.
•
Yellow:
Test pattern generator has been activated.
• Red: Signal loss.
• Off: Input/Spigot not in use.
As an output, this shows the following port status:
•
Green:
Valid flow is detected.
• Yellow: Test pattern generator has been activated.
• Red: Flow is not found or invalid.
• Off: Output/Spigot not in use.
See also Spigot Pages , on page 80 and Logging - SDI Info , on page 89
for more information.
SFP 1 to SFP 4
status LEDs
Shows the SFP 1, 2, 3, and 4 link status:
• Blue: Link OK (25G/50G/100G SFP).
• Blue flashing: SFP detected, link down (fiber not connected,
different FEC selection from host).
• Unlit: SFP not detected.
See also Ethernet Pages 1 and 2 , on page 62 and Logging - Network ,
on page 96 for more information.
DIAG status LED Shows the following states:
•
Green:
PTP-LOCK OK.
• Off: PTP-LOCK Fail.
See also Time Sync Configuration , on page 50 and Logging - System ,
on page 91 for more information.
BOARD status LED Shows the following states:
• Green: PTP-SYNC OK. PTP being used and clocks are within the
accepted range.
• Off: PTP-SYNC Fail. PTP being used but clocks haven't
synchronized /- 1mS.
PTP status LED Future use.