GRASS VALLEY KayakDD-1, Planning And Installation Manual

Page: 46 / 90

KayakDD-1 Digital Production Switcher
Jack Designation Note
J41
J42 REFERENCE Reference input, BNC / 75 ohms
Loop through sync input for analog Blackburst or
CCVS signal.
J19
:
J24
RS 485 PORTS Six control ports, 9-pin D-type female
RS485 serial ports for devices such as DVEs, Editors,
Routers and for Machine Control (Disk Servers, VTR).
J43 GPI/O - TALLY 50-pin D-type female
General-purpose interface connector with 8 input
channels and 32 output channels.
The connector is used for Tally also.
Refer table below for respective pin assignment.
J44 LAN RJ45 connector for connection to the Control Panel.
An interconnecting cable with a length of 10 m is
enclosed. Cables with lenghs of 20m or 50m can be
ordered optionally.
J2 DC POWER IN Input connector for external DC Power Supply for
redundancy (High current D-Sub, female).
Input voltage: 48V/ 5A
Note:
The external power supply unit must comply with
the SELV (Safety Extra Low Voltage) standard
exclusively. ELV and TNV
standard is not
permitted!
Additionally the 8V DC voltage for RAM Recorder
buffering can be supplied via this socket.
Refer table below for respective pin assignment.
J3 DC POWER
OUT
Output connector for Panel DC Power Supply.
(High current D-Sub, male).
Output voltage: 48V/ 3A
An DC power interconnecting cable with a length of
10 m is enclosed.
Planning and Installation Manual 45