1-2
1.2 Part Names and Functions
Front View/Control Panel
(1) Top cover
Control Panel
(4) Document guides
(3) Top cover open levers
(5) POWER button/LED
(6) PAPER LED
(7) ERROR LED
(8) EJECT key
(9) STOP key
(2) Paper sensors
Front View
(1) Top cover ....................... Open the top cover to clean the document hold-down unit and
transparent contact plates.
(2) Paper sensors ............... These sense whether a document is present in the scanner.
(3) Top cover open levers ... Press these levers to open the top cover.
If the top cover is opened during a scanning operation, the operation will
be stopped compulsorily.
(4) Document guides .......... Use these guides to determine the position of a document when you
load the document.
Control Panel
(5) POWER button/LED (blue)
................................ Controls the on/off status of the power supply to the scanner.
Lit: The scanner is turned on.
Flashing: Flashes when the scanner is in power-saving mode.
Unlit: The scanner is turned off.
(6) PAPER LED (green) ...... Lit: Lights when a document has been loaded.
Flashing: Flashes while image data is being scanned.
Unlit: Normal status (Local status).
(7) ERROR LED (red) ......... Lit: Lights to indicate a hardware error.
Flashing: Flashes when any of the following occurs:
• A document is detected during the self-test when the scanner is turned on
• When a paper jam is detected
• When the top cover is open
• When the document length is shorter than the specified scan length*1
*1 When "Confirm" has been selected for the End-of-paper Processing
setting in the driver software
Unlit: Normal status
(8) EJECT key .................... Press this key to feed the document.
If this key is pressed when the scanner is in document-loaded status, the
document-loaded status is canceled and the document is ejected to the
front of the scanner.
If this key is pressed after the scanning operation has been canceled or
after scanning of the document was halted partway through the
scanning operation, the document-loaded status is canceled and the
document is ejected to the rear of the scanner.
