![background image](http://html1.mh-extra.com/html/graco/reactor-e-30i/reactor-e-30i_repair-parts_2251586058.webp)
Repair
Installation
1. Applygrease liberallyto washers (307, 308,
318), all gears, and inside drive housing (302).
2. Install one bronze washer (308) in drive housing,
then install steel washers (307, 318) as shown.
3. Install second bronze washer (308) on gear
cluster (304) and insert gear cluster in drive
housing.
Note
Drive housing crankshaft must be in line
with crankshaft at other end of motor.
See
Fig. 13, page 56
.
4. Push drive housing (302) onto motor (301).
Install screws (312, 319) and washers (314).
Note
If bearing housing (303), connecting rod
(305), or pump (306) were removed,
reassemble rod in housing and install
pump, see
Install Pump, page 56
.
5. Route cycle counter switch cable (321) under the
motor fan and inside the conduit. Connect to port
#6 on the MCM and close conduit with tie wraps.
6. Install bearing housing (303), screws (313), and
washers (315). Pumps must be in phase (both at
same position in stroke).
7. Install cover (77) and screws (78).
8. Install motor shield (56) and screws (61) , see
Proportioners
.
Figure 14
58
3A1706K
All manuals and user guides at all-guides.com
Summary of Contents for Reactor E-30i
