Operation
306817N
9
Useful Hints
Hold the spray nozzle about 2 feet (0.6 m) from the
surface and completely mist-wet the object you are
cleaning. Let it soak briefly, then use the spray to
“chisel” the dirt off—keep the nozzle about 6 in. (152.4
mm) from, and at an angle to the surface. If some dirt
remains, wet the surface again. Let the object soak a
little longer, then hold the nozzle as close as possible
and spray to blast the dirt off.
F
IG
. 2
After all the dirt is cleaned off, rinse all the solution off
with clear, cold water. When you are through cleaning,
close the air petcock and follow the Pressure Relief
Procedure, page 8.
Shutdown and Care of Unit
When shutting down for the day or weekend, shut off the
main air supply and relieve the pressure. Rinse all
solution off the equipment with clear, cold water, Shut
off the water supply valve and relieve the water
pressure.
Check the air line lubricator (3) often and keep it filled
with oil. Also check the pump packing nut regularly and
keep it just tight enough to stop leakage, but no tighter.
Use a 1/4 in. diameter rod to tighten.
WARNING
To reduce the risk of serious injury whenever you are
instructed to relieve pressure, always follow the
Pressure Relief Procedure, page 8.
6018b
34
9
19
16
10
1
7
24
3
15
NOTICE
Do not allow the pump to run dry. It will quickly accel-
erate to a high speed, causing damage. If your pump
is running too fast, stop it immediately and check the
fluid supply. If the container is empty and air has
been pumped into the lines, refill the container and
prime the pump and the lines, or flush and leave it
filled with a compatible solvent. Eliminate all air from
the fluid system.
WARNING
To reduce the risk of serious injury whenever you are
instructed to relieve pressure, always follow the
Pressure Relief Procedure, page 8.
