308986
3
Warnings
Warning Symbol
WARNING
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result in
serious injury.
D
This equipment is for professional use only.
D
Read all instruction manuals, warnings, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check the equipment daily. Repair or replace worn or damaged parts immediately.
D
Do not exceed the maximum working pressure of the lowest rated system component. See the
Technical Data
section of all the equipment manuals.
D
See Configurator Product Order Form 309002 for important pressure rating information. The maxi-
mum working pressure of each model is also shown on the pump identification plate. Be sure that
all dispensing equipment and accessories are rated to withstand the maximum working pressure of
your pump. Do not exceed the maximum working pressure of the lowest rated system component.
D
Never operate the pump without the automatic pressure relief valves and drainage kits installed.
These valves relieve fluid pressure through a drain port at the bottom of the valve if the displace-
ment pump pressure exceeds the working pressure.
D
Never exceed the recommended working pressure or the maximum air inlet pressure stated on
your pump or in the Configurator Product Order Form 309002 .
D
Do not lift pressurized equipment.
D
Use only Graco approved hoses. Do not remove hose spring guards, which help protect the hose
from rupture caused by kinks or bends near the couplings.
D
Route the hoses away from the traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180
_
F (82
_
C) or below –40
_
F (–40
_
C).
D
Do not use the hoses to pull the equipment.
D
Use fluids and solvents that are compatible with the equipment wetted parts. See the
Technical
Data
section of all the equipment manuals. Read the fluid and solvent manufacturer’s warnings.
D
Comply with all applicable local, state and national fire, electrical and other safety regulations.
Summary of Contents for HYDRA-CAT FIXED RATIO
Page 38: ...38 308986 Notes...
Page 39: ...308986 39 Notes...
