Repair
332514J
29
5. Remove screws (116) from motor control box cover
(120) and remove cover and gasket (119) (F
IG
. 53).
6. Remove nuts (134) as shown in F
IG
. 54. Remove
washers (135) and motor wires from terminals.
Save these parts to use them for reassembly.
7. Disconnect sensor cable (117a) from motor control
board (F
IG
. 54).
8. Use a wrench to loosen strain relief (a) and remove
wiring harness from housing (F
IG
. 55).
9. Remove screws (125) and washers (124) holding
motor (123) to gear box housing (101). Remove
motor. Verify o-ring (122) was removed with motor.
(F
IG
. 56)
If o-ring (122) is still inside the gear box housing
(101), remove it.
Discard these parts in accordance with all safety
regulations.
F
IG
. 53
F
IG
. 54
116
120
119
134
117a
115
134
135
F
IG
. 55
F
IG
. 56
a
115
101
123
124
125
122
Summary of Contents for Dyna-Star 77X000
Page 45: ...Notes 332514J 45 Notes...