![background image](http://html1.mh-extra.com/html/graco/dyna-star-77x000/dyna-star-77x000_instructions-manual_2253486024.webp)
Repair
24
332514J
Reassembly
NOTE:
•
Before reassembly carefully clean and inspect all
parts and pump surfaces for scratches and damage.
A pump with damaged parts will not hold pressure
or operate efficiently.
•
Use all new parts included in kit for reassembly.
1. Apply a thin layer of grease to the packing u-cup
(202).
2. Use a flat, blunt-end tool to seat u-cup (202), with
the lips facing down, into the pump adapter (2) (F
IG
.
34).
NOTE:
Do not damage u-cup seal on threads during
installation.
3. Install hex nut (201) inside pump adapter (2). Use a
wrench to tighten nut securely (F
IG
. 34). Torque to
18-22 ft lbs (24 - 30 N.m)
4. Apply a thin layer of grease to the surface of dis-
placement rod (212). Slide rod into the pump
adapter (2) in the direction shown in F
IG
. 35 only.
5. Slide together piston rod (213) and piston seal (214)
(F
IG
. 36).
6. Thread piston rod (213) into end of displacement
rod (212). Hand tighten the two pieces together
securely, ending with hole (213a) (F
IG
. 36) aligned
with hole (212a) (F
IG
. 37).
F
IG
. 34
2
202
lips
down
202
201
2
NOTICE
Sliding displacement rod (212) into the pump adapter
from the other side of the pump adapter (2) could
damage the throat seal (201), resulting in a poor seal
and fluid leakage during operation.
F
IG
. 35
F
IG
. 36
212
2
213
214
213a
Summary of Contents for Dyna-Star 77X000
Page 45: ...Notes 332514J 45 Notes...