Install the Gateway Assembly Hardware
3A7639A
7
Install the Gateway Assembly Hardware
Location
Install the Gateway Assembly near the Graco System
Controller in a non-hazardous location.
Mounting
1.
See
2.
Ensure the wall or mounting structure is sturdy
enough to support the assembly and connection
cabling, and without excessive vibrations that could
cause reduced component performance or failure.
3.
Using the equipment as a template, mark the
mounting holes on the wall at a convenient height
for the operator and so equipment is easily accessi-
ble for maintenance.
4.
Drill mounting holes in the wall. Install anchors as
needed.
5.
Bolt equipment securely.
This equipment is not for use in explosive
atmospheres or hazardous locations. To reduce the
risk of fire or explosion, do not install equipment
approved only for non-hazardous location in a
hazardous location.
F
IG
. 1: Gateway Assembly Typical Installation
TI13939b
Computer (PC)
Programmable Logic Controller (PLC)
Gateway Assembly
Graco System Controller
USB Cable
(included with all
models); for initial
setup only
2-wire twisted
pair cable, with
shield wire,
CATV cable or
fiber optic cable
PLC Communication
Wire/Cable
(protocol dependent)
NON-HAZARDOUS LOCATION