![background image](http://html1.mh-extra.com/html/graco/24l097/24l097_instructions-parts-list-manual_2251064036.webp)
Flush
Flush
Flush Mode
Mode
Mode Operation
Operation
Operation
The data used to operate Flush Mode is configured
in
Setup Screen 12: Flush Mode, page 52
.
When Flush Mode is activated, the fluid regulator
is set to the percentage drive value from the setup
screen. The atomizing air regulator is set to zero.
This runs for the selected amount of time. The
fluid volume that flowed during the flush process is
compared to the minimum flush volume from the
setup screen. If the volume was not achieved, the
“SP” alarm is activated. The fluid volume is tracked
as a solvent in the Job Log.
Table
Table
Table 3
3
3 Flush
Flush
Flush Mode
Mode
Mode Run
Run
Run Screens
Screens
Screens
Description
Description
Description
Examples
Examples
Examples
Flush Mode
active
Flush Mode
complete
The following icons are available on the Run Screen
in Flush Mode:
Key
Key
Key
Enter the screen.
Atomizing air regulator
Flow rate target
Current fluid pressure
Flush Mode – No flow detected
Flush Mode Countdown Timer
Move between Run Screens.
36
3A6948A