![background image](http://html1.mh-extra.com/html/graco/232076/232076_instructions-manual_2251032010.webp)
10
308238
Operation
CAUTION
To prevent the system from overheating, do not
leave the control in the dispense mode without
dispensing for longer than 1 hour.
NOTE:
Refer to Fig. 3, page 11.
Program the Security Code and Set the
Units of Measurement
A four digit security code is required to activate the
control after turning it on. This prevents unauthorized
use of your system. Refer to the instructions on the
last page of this manual to set the security code.
The control is factory-set to dispense in quarts (U.S.)
or liters (metric). Refer to the instructions on the last
page of this manual to change the units of measure-
ment. Tear out the last page and keep it in a secure
place.
Activate the Control
Turn on the switch at the rear of the control. During
power-up, all display segments must show and all
station and dispense lights must light steadily for 3 to 4
seconds. When the display shows four dashes, enter
your security code.
Enter the Order
Press the station number key for the appropriate fluid.
The light on the key will come on.
Press the white keys firmly to enter the amount.
For example,
to enter 25.4 units, press the
10
twice,
the
1
five times, and the
0.1
four times.
If you make a mistake, press
STOP/CLEAR
and enter
the total amount again.
NOTE:
Holding-down an amount key will cause the
digit to change continually until the key is released.
Press
DISPENSE
. The digital display shows all zeros
and the
DISPENSE
light blinks. As the order is dis-
pensed, the display counts up and the fluid to the reel
is shut off when the preset amount is delivered.
To Check the Preset Amount During
Dispense.
Press and hold
AMOUNT PRESET
. The order contin-
ues to be delivered unless you stop or clear it.
To Stop the Dispense and Check the
Preset Amount
Press
STOP/CLEAR
and then press and hold
AMOUNT PRESET
to verify the original order. Press
DISPENSE
to continue the order.
To Stop or Clear an Order
Press
STOP/CLEAR
twice to cancel and clear the
order.
NOTE:
The control delivers just one fluid to one station
at a time. During delivery, all pads are inactivated
except
AMOUNT PRESET
and
STOP/CLEAR.
To Find the Total Units Delivered of Each
Fluid
Press any station key for one fluid. Press and hold
TOTAL
to read the amount. Repeat for the other fluid.
Summary of Contents for 232076
Page 21: ...21 308238...