Graco 232076, Instructions Manual

Page: 22 / 22

tear out page along this line
22 308238
Programming Security Code
and Changing Measurement Units
For the Fluid Commander Dispensing Control
TEAR OUT THIS SHEET ALONG THE DOTTED LINE
and keep it in a secure place after initially entering
the security code and setting the measurement units.
TO PROGRAM YOUR SECURITY CODE
1. Turn on the control.
2. When the display shows – – – – press the follow-
ing keys:
DISPENSE
,
TOTAL
, most lower right station
key, and
0.1
key.
3. The display shows
P P P P
.
4. Enter any four station key numbers; this is your
security code.
5. Enter the same four numbers again to activate the
control.
6. Record the sequence of numbers and keep in a
secure place.
TO CHANGE MEASUREMENT UNITS
(Gallon, Quart or Pint only – controls measured in liters
cannot be changed)
1. Turn on the control.
2. When the display shows – – – – press the follow-
ing keys:
DISPENSE
,
TOTAL
, most lower right
station key, and
TOTAL
.
3. The display shows
L1
and the station lights come
on for the first fluid.
4. Press the
0.1
key to change the measurement
units.
5. Press any station key for the next fluid, and press
the
0.1
key to change units.
6. Press
TOTAL
to end.
7. Enter your security code to activate the control.