8
Remote Control
8.1 Web Browser Control
The m108 has a built-in web browser controller allowing remote control from most web enabled Mac,
Windows, iOS and Android devices. This control has been optimized for Chrome, but will operate on
most modern web browsers (excluding Internet Explorer). This makes control of any m108 on an ip LAN
as simple as entering the m108's IP address into the browser's navigation window, and the web browser
control from that preamp will automatically load and connect (See above sections for selecting the eth-
ernet remote control mode and ethernet setup).
The m108 web browser control provides access to mic preamp and ADC configuration and status. The
available control and display features are as follows:
1. Channel number: the preamp channel number as determined by the preamp device ID
2. Channel name: the user defined name for each preamp channel. Names are limited to standard
alpha-numeric characters and have a maximum length of 11 characters.
3. 0dBFS Over indicator: Illuminates red when the signal level has clipped on the channel. This
indicator is sticky and is cleared by clicking on it.
4. Signal present indicator: Illuminates green when signal level > -60dBFS is present on the
channel.
5. Gain level adjustment via up/down buttons
6. Gain level adjustment via direct numerical entry
7. 48V phantom power switch: click to toggle phantom power on the channel
8. Phase Reverse switch: click to toggle the phase reverse on the channel
9. Ribbon Mic Mode switch: click to toggle the ribbon mode on the channel
m108 Owner's Manual
page 27
1
3
4
5
6
2
7
8
9
10
11
12
13
14
15
16
17
