15
1/4" X 2" Phillips
Pan Head Screw
3/16" Flat Washer
1/4" Jam Nut
Table Splice
1/4" X 3/4" Phillips
Pan Head Screw
1/4" X 2" Phillips
Pan Head Screw
Middle Leg Spacer
3/16" Flat Washer
1/4" Jam Nut
• The 1/4 X 3/4” phillips pan head screws will go through the
end two holes with a washer and jam nut on the end.
• Follow the above steps for the other side
Step 10: Middle Leg Spacer Assembly
Parts Needed: 1- Crib Table (assembled)
1*- Queen Table (assembled)
2-
Middle Leg Spacer
2*- Table Splice
4 or 8*- 1/4” X 2” Phillips Pan Head Screw
4*- 1/4” X 3/4” Phillips Pan Head Screw
4 or 12*- 3/16” Flat Washer
4 or 12*- 1/4” Jam Nut
• You will not want to completely tighten the nuts on this
step until you have completed track installation in step
11. Your tracks will go in easier if the bolt is not tight.
• Place the flat side of the Middle Leg Spacer
against the front crib table aluminum track support
(as show above, and to the left).
• Put a phillips pan head screw through the left hole following the same steps as you did for the right.
• Follow the above steps to attach the Middle Leg Spacer to the back crib table aluminum track support.
• Place your Crib Table #2 next to you Queen Table #3.
• Where your Crib Table meets your Queen table you will
place a Table Splice (flat end against the aluminum track
support).
• You will place a 1/4” X 2” phillips pan head screw through
the center two holes in the aluminum track support and then
through the Table Splice. A washer and jam nut will go on the
end of the screws.
• You will place a 1/4” X 2” phillips pan
head screw through the center two holes
in the aluminum track support and then
through the Table Splice. A washer and jam
nut will go on the end of the screws.
• Put one phillips pan head screw through the
right most hole in the front crib table aluminum
track support, which will then go through the
Middle Leg Spacer.
• You will then put a flat washer on the end of
the screw, which will be followed by a jam nut.