GPX 250r TSE, Maintenance Manual

Page: 28 / 104

GPX MOTO
www.GPXMOTO.com + www.GPXMOTOUK.com
- 27 -
RIDING INSTRUCTIONS
PREPARATION BEFORE RIDING
1. Check fuel level in fuel tank and replenish if necessary.
2. Check fluid level in front brake fluid reservoir and replenish if necessary.
3. Check fluid level in rear foot brake fluid reservoir and replenish if necessary.
4. Check brake pad wear condition of the front brake.
5. Check brake pad wear condition of the rear brake.
6. Check that both brakes operate correctly.
7. Check the antifreeze level.
8. Check the chain for the condition and correct tension
9. Inspect rear sprocket, engine sprocket and chain guide structure to ensure the condition is good.
10. Check the chain adjuster to ensure the lock bolts are tight.
11. Check the outer surface of the tire.
12. Check tire pressure.
13. Check battery level.
14. Check the thickness of the front disc brake.
15. Check the thickness of the rear disc brake.
16. Check the torque of each fastener.
17. Check the rear sprocket to ensure the condition is good.
18. Check engine casings and plastic cover parts to ensure a good condition.
19. Check the fuel tank switch.
PRECAUTIONS FOR STARTING
The required to start the GPX are as follows:
1. Turn the petrol tank switch to the "ON" position;
2. Pull up the choke knob on the carburettor to activate it ;
3. Turn on the ignition key;
4. Pinch the clutch lever with the left hand;
5. Pinch the brake lever with the right hand;
6. Push the starter button until the engine starts but no longer than 2 seconds;
7. Release the starter button after the engine starts.
8. Push the choke knob down to deactivate it.
PRECAUTIONS FOR STOPPING
1. Check the condition of the vehicle and the rider’s Equipment before starting off.
2. Speed up slowly when just starting off.
3. Start in gear “1” to ensure safety.