Software
English, Revision 01, Date: 14.04.2009
13
Figure 4
Screenshot: Antenna menu
-
By pressing
F
the frequency in the range of 1 to 28 kHz can be modified.
Please
note that the antenna G 19210-C works in a range from 3 to 25 kHz!
-
D
helps adjusting the threshold which refers to the sum voltage. When is thresh-
old is exceeded, the front LED CDx and/or the corresponding bits in the system
status are set .
-
By using
H
the distance between the guide wire and the bottom of the sensor
can be modified.
-
With
I
the internal height, which is specified for each type of antenna, can be
entered.
NOTE!
The sum of the values entered under
H
and
I
are used to cal-
culate the distance
-
C
starts the calibration of the distance output. Now the corresponding antenna
has to be moved in an area of ±2x height over the guide wire. For the calibration a
10 kHz wire frequency is recommended as the frequency compensation is also
referred to this frequency.
-
With
Q
the menu can be left.
S1: 1 D1: -10 S2: 10816 D2: -4403 X1:-256 mm X2: -50 mm Status: 0x40
(F)req 1 select [/Hz]: 10000
(D)etect Level 1 [/Smpl]: 1000
(H)eight of Antenna mounting [/mm]: 60
(I)nternal height [/mm]: 35
(C)alibrate
(Q)uit