5/16" WASHER
5/16 X 3-1/2"
LAG SCREW
2 X 6 X 30-3/4"
UPPER LEVEL SIDE
BOTTOM PANEL BOARD
(OFFSET HOLES DOWN)
5/16 X 4-1/2"
HEX BOLT
MODEL II ONLY
5/16" WASHER
5/16 X 3-1/2"
LAG SCREW
5/16 X 4-1/2"
HEX BOLT
2 X 6 X 58"
BOTTOM PANEL BOARD
(OFFSET HOLES DOWN)
2-1/2" WOOD SCREW
STEP 48: UPPER LEVEL BOTTOM PANEL BOARD
1: ONE 2 X 6 X 30-3/4" UPPER LEVEL BOTTOM PANEL BOARD IS USED IN THIS STEP, OFFSET HOLES DOWN, ON THE
REAR OF THE FORT. LINE THE TOP HOLES OF THE UPPER LEVEL BOTTOM PANEL BOARD WITH THE HOLES IN THE
CORNER POST.
2: THE BOARD WILL SECURE TO THE FORT USING ONE 5/16 X 4-1/2" HEX BOLT WITH A 5/16" WASHER, FOLLOWED
BY ONE 5/16 X 3-1/2" LAG SCREW WITH A 5/16" WASHER. USE A LEVEL TO MAKE SURE THE BOARD IS INSTALLED
PROPERLY.
3: NO HARDWARE WILL BE USED ON THE SIDE AT THE CENTER POST AT THIS TIME.
1: ONE 2 X 6 X 58" BOTTOM PANEL BOARD IS USED IN THIS STEP, OFFSET HOLES DOWN, ON THE REAR OF THE FORT.
LINE THE TOP HOLES OF THE UPPER LEVEL BOTTOM PANEL BOARD WITH THE HOLES IN THE CORNER POST.
2: THE BOARD WILL SECURE TO THE FORT USING TWO 5/16 X 4-1/2" HEX BOLTS WITH 5/16" WASHERS, FOLLOWED
BY TWO 5/16 X 3-1/2" LAG SCREWS WITH 5/16" WASHERS.
3: USE TWO 2-1/2" WOOD SCREWS IN THE CENTER OF THE BOARD TO SECURE IT TO THE UPPER LEVEL REAR CENTER
POST.
MODEL I ONLY
84
