EN 21
THE APPLIANCE IS NOT EQUIPPED WITH
A POWER CABLE
(depending on the model)
A device disconnecting the appliance from mains,
whose off contacts of all poles are in a minimum
distance of 3 mm, must be built in the stable electrical
energy distribution before the appliance.
Solely an authorised, skilled person may install the
range. The authorised person is obliged to set the
range cooking plate in horizontal position, to connect
it to the mains and to check up on its duty. Installation
of the range must be confirmed in the certificate of
warranty.
It is recommended to use a two-phase connection of
the range with the aid of an H05VV-F4G-2,5 type
connecting cord (previously CGLG 4Cx2,5), (circuit
breaker 2x16 A).
For single-phase connection use an H05VV-F3G-4
(previously GGLG3Cx4) (circuit breaker 32
– 40 A to
the type).
It is necessary to brace the conductor ends with
pressed terminals against fraying.
After bracing the conductor ends beneath the terminal
board screw heads place a cord in the terminal board
and secure it by a clip against tearing. Eventually
close the terminal board cover.
CLAMP PROTECTION
The clamps should be protected by a clamp cover,
see additional equipment. Electric shock danger.
GAS CONNECTIONS
FACTORY DEFAULT SETTINGS
−
Gas appliances are tested and fitted with the sign.
−
Has appliances are supplied sealed with burners
adjusted to natural gas type H or E (20 or 25
mbar), or to liquefied natural gas (50 or 30 mbar).
−
The adjustment conditions for this appliance are
stated on the label (or data plate).
−
Before connecting the appliance, make sure the
local requirements for connection (gas type and
pressure) are compatible with the appliance
settings.
−
If the gas you are using is not compatible with the
current settings on your appliance, call a service
technician or the distributor.
−
Modifying the hob to operate with a different type
of gas requires replacement of the nozzles (see
section NOZZLE TABLE).
−
In case of repairs or if the seal is damaged, the
functional parts have to be tested and re-sealed in
compliance with the installation instructions. The
functional parts include the following: fixed nozzle
for large flame and adjustable regulation screw for
small flame.
CONNECTING TO GAS SUPPLY
−
Appliance has to be connected to the gas mains or
the gas cylinder according to the instructions of
your local gas distribution company.
−
There is a gas connection plug on the right-hand
side of the appliance, with external thread EN ISO
228-1 or EN 10226-1 / -2 (depending on the
connection regulations in the respective country).
−
A liquefied natural gas connection and a non-metal
gasket are also supplied. (depending on the
model)
−
When connecting the appliance to the gas supply,
the G 1/2 or R 1/2 part has to be held to prevent it
from rotating. (depending on the model)
−
Use approved non-metal gaskets and approved
sealants for sealing the connection joints. Only use
each gasket once. The thickn
ess of flat non-metal
gaskets may be deformed by up to 25%.
−
Connect the appliance to the gas supply using a
certified flexible hose. The hose should not touch
the upper part of the appliance.
Connection with a flexible hose
If the appliance is connected with a flexible hose, the
path of the hose indicated with "A" is not acceptable.
If a metal pipe is used, option "A" is permissible as
well.
