398309
• Cooking hobs can be installed into worktops that are 30
to 50 mm thick.
• If the board is thicker than 40 mm, its inner edge should
be trimmed, or ground (Figure A). Thus, suffi
cient air
circulation will be provided.
• If the thickness of your counter top exceeds 30 mm,
then the opening for the hob should be made in the
middle of the oven, with suffi
cient clearance from the
front edge of the counter top so that the induction hob
does not touch the oven shield.
• If you wish to install the induction hob into an existing
opening, make sure if this is possible given the required
installation dimensions (installation depth of 56 mm).
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• By means of the supplied screws 4 fasten the supplied
tightening brackets 4 fasten to the front and the rear
side of the cooking hob and to the prepared aperture.
• Connect the cooking hob to the mains power supply
(see instructions for the connection of the cooking hob
to mains power supply).
• Insert the hob into the cut aperture.
• Press the hob fi rmly towards the worktop from above.
• For screwing down the fi xing clip it is not allowed to
use screws longer than 6,5 mm.
Installation procedure
20
Summary of Contents for IT65KR
Page 27: ......
