Gorenje IT65KR, Instructions For Use, Installation, And Connection

Page: 14 / 28

398309
• Value can be set from 01 to 99 minutes. Shut-off timer
can be set for each cooking zone.
• To check the
remaining time
, select the corresponding
cooking zone and activate the timer function. Press the
»–« or »+« sensor (E) to change the setting. (Press the
»–« and »+« sensor (E) simultaneously and sequentially
to choose between active settings.)
• When the set time expires , »00« will fl ash on the
display; in addition, relevant decimal point will fl ash
at the shut-off timer. A short beep will be heard. To
acknowledge and stop the beep, press any key; after 2
minutes, the beep will end automatically.
The cooking hob is fi tted with overheating protection
sensors. If the temperature rises too high, individual
cooking zones or even the entire cooking hob can be
temporarily switched off automatically.
Error, possible cause, solution
• Continuous beep and Er03 fl ashing on the display.
- Water spilt over sensor surface, or an object placed
over the sensors.
Wipe the sensor surface.
• Flashing E/2
- The cooking zone has overheated. Wait until it cools
down.
• E/3 fl ashes
- Unsuitable cookware that lacks ferromagnetic
properties. Use another pot or pan.
In case of an operation failure or if the fault /
error indication does not disappear, disconnect
the cooking hob from the power mains for a few
minutes (undo the fuse or turn of the main switch);
then, reconnect it to the power mains and turn on
the main switch key.
If the problems persist, call a service technician.
Safety functions and
error display
14