EN 15
Immediately remove any sugar or sugar-laden food
from the glass ceramic hob using a scraper, even if
the hob is still hot, as sugar may permanently
damage the glass ceramic surface.
Discolouration of the glass ceramic surface
does not affect the operation or stability of the
surface. Such discolouration is most commonly a
result of food residues burnt onto the surface, or it
may be caused by some cookware materials (such
as aluminium or copper). Such discolouration is very
difficult to remove entirely.
Note:
Discolouration and similar flaws only affect the
appearance of the hob and do not directly affect its
function. Removing such flaws shall not be covered
by the warranty.
OVEN
Clean the oven walls with a damp sponge and
detergent. To clean stubborn stains burned into the
oven wall use a special detergent for enamel. After
cleaning carefully wipe the oven dry. Clean the oven
only when it is completely cold. Never use abrasive
agents, because they will scratch enameled surface.
Wash the oven utensils with a sponge and
detergent. You can also use special detergents to
remove rough stains or burns.
USING THE
„AQUA CLEAN“
FUNCTION
Turn the COOKING SYSTEM SELECTOR KNOB to
position
AQUA
CLEAN
.
Set
the
TEMPERATURE KNOB to 70°C.
Pour 0,6 l water into a baking tray and place it in the
lower guide.
After 30 minutes, food residues on the oven enamel
walls will have softened and they will be easy to
clean with a damp cloth.
Use the
“AQUA CLEAN“
system when
the oven has fully cooled down.
REMOVING AND CLEANING WIRE AND
TELESCOPIC EXTENDIBLE GUIDES
Only use conventional cleaners to clean the guides.
Hold the guides by the bottom side and pull them
towards the center of the oven cavity.
Remove them from the openings at the top.
Do not clean the extendible guides in
the dishwasher.
INSTALLING THE CATALYTIC INSERTS
Only use conventional cleaners to clean the guides.
Remove the wire guides or extendible guides.
(depending on the model)
Mount catalytic inserts onto the wire guides. The
upper part of the guides must be mounted into the
upper openings "A" in the catalytic inserts.
Place the wire guides with the catalytic inserts on
the upper openings in the side walls of the oven “A“.
Press them into the snap lock at the bottom “B“.
Do not wash the catalytic inserts in the
dishwasher.
REPLACING THE BULB
The bulb is a consumable and therefore not covered
by warranty. Before changing the bulb, remove the
trays, the grid, and the guides.
Disconnect the appliance from the power mains!
Undo the bulb cover and pull out or undo the bulb.
Halogen lamp: G9, 230 V, 25 W.
(regular bulb E14, 230 V, 25 W - depending on the
model)
Use protection to avoid burns
.
COMFORT DOOR CLOSING
(depending on the model)
Cookers are equipped with new secure door hinges
COMFORT. These special hinges guarantee very
quiet and gentle closing of the oven door.
If the force applied to close the door is
too strong, the efficiency of the system
can be reduced or the system's safety
can be affected.