Removing and replacing the oven door and glass panes
1
First, fully open the door (as far as it will go).
2
Oven door is attached to the hinges with
special supports that also include safety levers.
Rotate the safety levers towards the door by
90°. Slowly close the door to a 45° angle
(relative to the position of the fully closed door);
then, lift the door and pull it out.
Oven
door glass pane
can be cleaned from
the inside, but it has to be removed from the
appliance door first. First, proceed as described
under item 2, but do not remove it.
3
Remove the air guide. Hold it on the left-
and right-hand side of the door with your
hands. Remove it by slightly pulling it towards
you.
4
Hold the door glass at the upper edge and
remove it. To the same for the second and third
glass pane (depending on the model).
5
To replace the glass panes, observe the
reverse order.
INFORMATION!
To replace the door, follow the reverse order. If the door does not open or close properly, make
sure the notches on the hinges are aligned with the hinge beds.
WARNING!
The oven door hinge can close with considerable force. Therefore, always rotate both
safety levers to the support when fitting or removing the appliance door.
Soft door closing and opening
Oven door is fitted with a system that dampens the door closing force, starting at the 75-degree angle.
It allows simple, quiet, and gentle opening and closing of the door. A gentle push (to a 15° angle
relative to the closed door position) is enough for the door to close automatically and softly.
WARNING!
If the force applied to close the door is too strong, the effect of the system is reduced or
the system will be bypassed for safety.
32
