Equipment included :
1 : Stand up paddle board / surfboard and included
fi
ns regarding technical specs.
2 : Carrying bag and repair kit
3 : In
fl
ation pump with nozzle and gauge meter
Assembly / In
fl
ation :
To use your in
fl
atable board GONG Chip :
In
fl
ate your SUP by using the GONG pump supplied with your board. This pump has the in
fl
ation skills required and the tips are
compatible with the valve of your board (non-contractual photos).
1 : Choose a soft and clean
surface to place your gear.
2 : Open the in
fl
ation cap
valve which is close to the
nose of the board.
3 : Make sure the valve
button is in outter
position for in
fl
ation. To
release it, press the button
and twist it left or right.
4 : Connect the aire hoose
to the board by putting
the tip into the valve.
5 : In
fl
ate to the required
pressure:
15 PSI. It is
normal to hear a little air
out
fl
ow at the pump
tube during in
fl
ation.
Indeed, the tightness of
the pipe is never perfect,
but the losses are
insigni
fi
cant. The gauge
meter starts to provide
guidance from a certain
pressure only, so it is
normal that this one
does not work at the
fi
rst
strokes
6 : Once the in
fl
ated
board, disconnect the
tube tip from the valve of
the board, and replace it
with the valve cap in order
to make it waterproof.
7 : To de
fl
ate the board,
open the valve cap, and
press the button
downwards. Twist it left or
right to lock it in low
position (de
fl
ation).
The pressure on the use of stand up paddle boards GONG is
15 PSI
. In case of high temperatures prolonged exposure, check the
pressure with the gauge provided and, if necessary slightly de
fl
ate your board. Do not respect the pressure of 15 PSI can
damage your gear, and the guarantee can not cover the damage.
Never in
fl
ate your board at less than 15 PSI.
Be careful not to turn the valve in de
fl
ation position when you engage hose ending. Otherwise the board will de
fl
ate when you
undock the pipe.
To put a removable US box center
fi
n :
The GONG Chip boards are equipped according to the models of
fi
xed
fi
ns only,
fi
xed
fi
ns +
removable
fi
n, or a removable
fi
n only.
1 : Remove the square from the screw and place it in the rail at the front of the box.
2 : Place the base of the
fi
n in the rail of the box and slide it at the position of your choice.
3 : Move the square in order to have him face the hole at the front of the
fi
n.
4 : Insert the hand screw into the hole and screw it there until the
fi
n is properly attached at ground level of
the case.
It’s normal if it’s a little bit di
ffi
cult to insert the US box
fi
n : the goal is to limit the movement of the
fi
n.
9
