EN
- 24
The HIPE 6’5 and 7’5 are equipped with a box at the front of the foil to keep your heading when you gain speed
on the water before flying with the foil.
1 - Slide the Nut inside the US Box towards the front of the Board.
INSTALLATION OF THE FIN
ASSEMBLY / DISASSEMBLY OF THE FOIL
3 - Turn your assembled Foil over and place it on your
board above the US boxes. Use the 4 screws (and
washers if necessary) to fix the foil to your board by
screwing them firmly into the brass squares.
Check the tightness of all the screws.
Yourboardis
nowreadytobeused.
For disassembly, do the reverse.
1 - Turn your board over on a smooth surface. After
sliding the first 2 rubber shims at the ends, insert
2 brass squares non traversing hole in each US
box.
2 - The shims allow you to fix the adjustment of your
brass squares and avoid losing them when you
handle the board. Place your squares opposite
the holes in the board. Block them between two
shims.
