EN
- 20
•Never leave your Board in direct sunlight. Excessive
temperature can damage the PVC and increase pressure, risk
breaking welds and causing leaks.
•After each use, rinse your Board in fresh water with the
valve closed and let it dry before storing it in its bag.
•DonotleaveyourBoardinflatedforlongperiodsoftime.
If you store it, without storing it in its bag, deflate it slightly to
lower the pressure and store it in a clean and dry place.
•TheHIPEisdesignedforrecreationaluseinSurffoil,Kitefoil,SUPfoil
and Wing foil. It offers you the performance in terms of stiffness of a rigid
board without the fragility on impact and bulk. But it is not intended for use in
competition or rental.
•Whenfoldingit,donotovertightenyourBoardalongtheCarbonPlate.
•Whennavigating,avoidrockyareasorsandbanks. A sudden impact with the
bottom can damage your Board.
•Incaseofloss,donotreplaceyournon-throughbrassinsertswiththrough
inserts. You risk piercing your Board by screwing your Top Plate onto the Board.
•DonotleavesandintheBoard’sUSrailsorfootstrapinserts.
•ObservethepressurerecommendationsforinflatingyourBoardbetween
15and20PSI.Do not under-inflate or over-inflate your board.
•DonotallowyourBoardtofallonthegroundhardontheCarbonPlate.
Preserveyourequipment.
•MakesuresandcannevergetintotheValveorBoard.
This could cause
damage.
•InordertoensurethelongevityandthegoodfunctioningofyourPump, do
not hesitate to check from time to time the lubrication of the piston inside your
Pump by adding silicone grease if necessary.
•Despiteallyourprecautions,andthesolidityofthePVC,itispossiblethat
youmanagetopierceyourBoardonaverysharprockforexample.The
marine grade PVC glue needed for the job can be found at any hardware store
or specialty boat shop.
