MONITOR PROGRAMMING
49
Turn off the monitor to be set, by pressing the door opener
button during 1 second.
Once it has been turned off, press the autoswitch-on button.
Keep the autoswitch-on button pressed and without releasing it,
press the door opener button.
The doorpanel will produce tones to indicate that the
device is ready to be set up.
The monitor will show the image and it will be possible
to release the other buttons.
Lift the handset from the monitor.
Press the doorpanel button.
The doorpanel and the handset will
produce tones.
To set up the monitor as the main one,
hang the handset up.
To set up the monitor as a slave one,
press the door opener button.
Each house must be equipped with just one main unit; if parallel-conected units exist,
they must be configured as slave, whether monitors or phones.
Make a call to make sure that the monitor has been properly set up.
Set up the other monitors in the same way.
At the end of the program process, the switch must be set to OFF.
If you forget to do this, the doorpanel will produce tones to indicate that
program mode has not been deactivated.
onitor program.
M
REMEMBER:
Monitors must be programmed only if some of them
are slave or if there are general doorpanels.
Find the configuration microswitch located in the rear part of the
doorpanel and set number 2 to ON.
The doorpanel will produce a tone, indicating that it has entered
program mode.
In systems with more than one doorpanel, this operation must be
carried out only in the main doorpanel of each building.
50
escription of T-740 Uno Phone
D
a
d
c
e
b
a.
b.
c.
d.
e.
f.
g.
Handset
Sound diffusion unit.
Microphone.
Fixing hole.
Phone cord connector.
Function button
Hang up button.
In order to connect the phone and to fix it to
the wall, it is necessary to open it.
Put a flat screwdriver in the proper openings
as shown in the picture and prise them
open.
Pass the cables through the proper hole and connect them to the terminal
block, as shown in installation diagrams. Close the phone as shown in the
picture, then connect the handset by means of the phone cord and hang it
up.
Do not install the device near heat sources, in places with dust or
fumes. The phone can be fixed in a universal box or directly to the
wall. To fix it directly to the wall, drill two 6mm holes in the position
shown in the picture, by means of 6mm screws and Ø3,5 x 25mm
screws.
g
f
e
TELEPHONE DESCRIPTION
unction button.
F
When the handset is lifted, it is possible to make a call to the porters exchange.
When a call is received or during communication, it enables the door opener.
