TELEPHONE PROGRAMMING
51
hone program.
P
Find the configuration microswitch located in the rear part of the
doorpanel and set number 2 to ON.
The doorpanel will produce a tone, indicating that it has entered
program mode. In systems with more than one doorpanel, this
operation must be carried out only in the main doorpanel of each
building.
Each house must be equipped with just one main unit; if parallel-connected units exist,
they must be configured as slave, whether monitors or phones.
Press the door opener button and, without releasing it,
lift the handset.
The doorpanel and the handset will produce tones to indicate
that the device is ready to be set up.
It is possible to establish an audio communication.
Release the door opener button.
Press the doorpanel button.
The doorpanel and the handset will
produce tones.
Make a call to make sure that the phone has been properly set up.
Set up the other phones in the same way.
At the end of the program process, the switch must be set to OFF.
If you forget to do this, the doorpanel will produce tones to indicate that
program mode has not been deactivated.
To set up the phone as the main one,
hang the handset up.
To set up the phone as a slave one,
press the door opener button.
If, when using the device, audio volume is inadequate, it is necessary to carry out some
adjustments, as shown in the picture.
The camera is equipped with an horizontal and vertical orientation device.
If orientation is not correct, change it.
Fix the doorpanel to the embedding box by means of the proper screws.
inal adjustments
F
ackbone code programming.
B
Find the configuration microswitch located in the rear part of the
detached house doorpanel and set number 5 to ON. Both
doorpanels will produce tones to indicate that program mode is
enabled. The coded doorpanel will display the “PROGRAM”
message.
In order to exit program mode, set microswitch number 5 of
the detached house doorpanel to OFF and press “C” button
of the general doorpanel.
Insert the code of the backbone to be programmed
(between 1 and 250), then 001code and press the
bell button. Both doorpanels will produce tones to
indicate that programming has been succesfully
carried out.
The general doorpanel enters programming mode
after pressing the key button and inserting the
installer secret code (factory value 1315).
golmar
13:15
REMEMBER:
It is necessary to program the backbone code only if the panel is part of a system
equipped with general doorpanel/s (see note).
0
1
O.K.
0
0
1
NOTE:
For this type of installation, please contact the technical trade department of
Golmar.
ANCEL
C
After programming the backbone, program monitors and telephones following the
instructions shown on page 49 and 51.
Program all the other doorpanels in the same way.
Do NOT program more than one house doorpanel at the same time.
BACKBONE CODE PROGRAMMING
52
This device can work as a partial doorpanel in building complexes with shared entrances . In this
kind of systems, each partial doorpanel must be programmed with a different backbone code
so that shared entrances recognize which is the partial doorpanel they have to call.
To carry out this operation, do as follows.
