golmar 50124319, Instruction Manual

Page: 47 / 56

153
Main
To the monitors
ideo installation with general entrance
door panel for residential complexes.
v
Coming
from previous page
154
1,50mm² 2,50mm²
0,25mm² 0,25mm²
RG-59 RG-59
Terminal
SECTIONS CHART
100m.
Distance
300m.
A , A , A, D
in out
V , V , V , V
in+ out+ in out
+, –, CV+, CV–
To the monitors
ideo installation with general entrance
door panel for residential complexes.
v
For longer distances than the specified contact with your distributor.
Example of riser with digital repeater
!
If any T-740 Uno or Platea/Tekna Uno is connected to an internal building door panel, a digital
repeater RD-Plus/Uno SE must be used, installed as shown in the diagram (for the configuration
of the RD-PLUS/UNO SE , see the TRD-PLUS/UNO SE manual).
!
GENERAL DOOR PANEL INSTALLATION DIAGRAMS
D2
D4L-PLUS
OUT
CTin
D1
JP1
IN
SW2
SEC
PRI
~ ~
+ + - -
M
Inner door panel BACKBONE 126
EL500 mode
D Malla V
in-
A
in
A
out
V
in+
V
out-
V
out+
CN2
+
- +
CV1 CV2
-
10
1
9
2
8
3
7
4
6
5
CN5
SW1
Lock release
Vdc
SW2
SEC PRI
~ ~
+ +
- -
Main
M
BACKBONE 127 Inner door panel
EL500 mode
D Malla V
in-
A
in
A
out
V
in+
V
out-
V
out+
CN2
+
- +
CV1 CV2
-
10
1
9
2
8
3
7
4
6
5
CN5
SW1
Lock release
Vdc
A1
BUS 1
+
Out
A1
In
-
D1 Vin
-
1
Vout
BUS 2
+ - D2 - Vout A2
SW1
SW3
RD-PLUS/UNO SE
JP1
UNO SYSTEM
PLUS SYSTEM
SW2
* *
*
Coaxial cable characteristics RG-59 B/U MIL C-17, (see page 110).
Malla
V
in-
V
in+
V
out-
V
out+
Malla
V
in-
V
in+
V
out-
V
out+
IMPORTANT NOTES:
To wire and configure the system properly, use this instruction manual and the ones enclosed in the
internal building door panels.
The installation diagram shows the connection of a video system with two general entrance door panels
and up to 127 internal building door panels (backbone/building).
In case of more than two general entrance door panels, wire them as the second is connected.
In video systems, use a D4L-Plus distributor at each door panel input except on the last one. Remove the
end of line jumper of all the distributors except in the last one.
In case of audio systems only, do not use coaxial cable neither distributors. On the buildings backbones
coaxial cable must be replace by a negative wire.
In video systems with use the D6L-Plus/2H distributor instead of D4L-Plus distributor. Take
off JP1 jumper of all the distributors except in the last one. Add a negative in the inner building
installation riser, (see page 147).
Below shows the connection of the
coaxial cable.
twisted pair
twisted
pair instead of
FA-Plus or FA-Plus/C
FA-Plus or FA-Plus/C