golmar 2PLUS, Installation Manual

Page: 6 / 28

DOOR PANEL INSTALLATION
ound module assembly.
S
ixing the door panel into the embedding box.
F
58
To place the module EL516SE (or EL 512),
center the hole on the upper side of the module cover with the corresponding
hole in the embedding box.
Lean the circuit on the lower flanges and screw it to the embedding box. In such case there are
more modules of the same type, repeat this procedure further below, or on the next box.
Insert the sound module in the grille module. For a
proper assembly, align the light push button
and the microphone of the sound module with
its own holes in the grille module.
Choose a direction to open the door panel; this selection should
facilitate the door panel wiring.
The opening direction is determined by the location of both hinge
springs, that have to be introduced through the clips which are found
at the end of the headers as it is shown in the picture. For example, if
the springs are placed on the two clips of the lower header, the door
pannel will open downwards; if they are placed on the right clips of
both headers, the door panel will
open to the left.
To hold the door panel on the embedding box,
insert the hinge springs into the embedding
box bolts as shown.
DOOR PANEL INSTALLATION
lace the embedding box.
P
oor panel modules assembly.
D
57
Pass the wiring through the hole made in the embedding box.
Fit, flush and level it. Then, once it is placed, remove the
protective labels from the fixation holes of the door panel.
Insert the lower closing head (marked ABAJO) in the lower module and fix it by screwing the module
shafts.
Place the module holder between the lower module and the next module, but make sure that the
holder notches are inside the door panel. Fix the following module screwing the shafts. Repeat this
procedure in case the door panel has another module (the maximum number of modules linked
vertically is three).
Insert the upper closing head (marked ARRIBA) in the last module and fix it using the supplied screws.