golmar 2PLUS, Installation Manual

Page: 12 / 28

POWER SUPPLY INSTALLATION
LOCK RELEASE INSTALLATION
ock release installation.
L
If the lock release is installed in a metal door, use a
and tap the hole.
In case of wood door, use a mm drill.
Ø3,5mm
drill
Ø 3
nstalling the FA-PLUS/C ver. 938072 power supply.
I
IMPORTANT: the lock release must be of 12V a.c. or d.c (see pages 71 to 76).
64
DIN 46277
To avoid damage, the power supply has to be firmly fixed.
Remember the current regulation forces you to protect
the power supply with a thermo-magnetic circuit
breaker.
To install the power supply on the wall, drill two holes of 6mm
and insert the wall plugs. Hold the power supply by means of
the specified screws.
Ø
The power supply can be installed on a DIN 46277 guide
by simply pressing it. To disassemble the power supply,
use a plain screwdriver to lever it, as it is shown on the
picture.
The FA-PLUS/C power supply uses 6 units over DIN guide.
Place the protection cover once the input terminals are wired.
DOOR PANEL INSTALLATION
inal adjustments.
F
L1
L2
+
BUS
amps wiring.
L
Once the nameplate labels are placed, wire the lamps from
all the modules with the terminals L1 and L2 of the sound
module.
IMPORTANT: If there are more than three push buttons
modules, use the EL512 relay to supply the lamps (see
diagram in page 69).
losing the door panel.
C
If after starting the system, it is considered that the audio volume is not
appropriate, do the necessary adjustments as it is shown.
63
IMPORTANT: Before closing the door panel(s), do a test
call and check all self-testing leds (page 62) don’t show
any error.
Fix the door panel to the embedding box using the
supplied screws and washers.
Finish the door panel assembly by pressing the closing
heads.
In case it is necessary to open the door panel once closed,
use a flat screwdriver to remove the closing heads.
Install or modify the equipment without the power connected .
The installation and handling of these equipments must be performed by authorised personnel .
Install the power supply in a dry and protected place without risk of drip or water projections.
Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
Do not block ventilation holes of the unit so that air can circulate freely.
M 4 x 8
3,5 x 25
DIN-7972
DIN-963
3,5 x 45
DIN-7971
3,5 x 45
DIN-7971