7
4. Insert the Rear Stabilizer Cover (67) into the
Rear Stabilizer (9).
Attach the Rear Stabilizer Cover (67) with two
M4 x 16mm Self-tapping Screws (52).
4
52
9
67
5
5. Orient the Upright (2) as shown. Have a second
person hold the Upright near the Frame (1).
See the inset drawing.
Locate the wire tie in
the Upright (2). Tie the lower end of the wire tie
to the Wire Harness (73). Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Tip: To prevent the Wire Harness (73) from
falling into the Upright (2), secure the Wire
Harness with a rubber band or a piece of
tape.
Slide the Upright (2) onto the Frame (1).
Tip: Avoid pinching the Wire Harness (73).
Attach the Upright (2) with two M10 x 74mm
Button Bolts (7), two M10 Split Washers (45),
and two M10 Locknuts (33).
Do not tighten the
Button Bolts yet.
2
33
45
7
73
1
1
2
73
Wire Tie
Wire Tie
Avoid pinching the
Wire Harness (73)
