9
12. Attach the Rear Stabilizer (12) to the Bench
Frame (10) with two M8 x 78mm Button Bolts
(91), two M8 Curved Washers (90), and two M8
Nylon Locknuts (88).
Tighten the M8 Nylon Locknuts (88) use in
steps 10–12.
14. Attach the Backrest (41) to the Backrest Frames
(18) with four M6 x 38mm Screws (73) and four
M6 Washers (92).
Do not tighten the Screws
yet.
15. Pull the Bench Knob (not shown) out as far as it
will go. Slide the Adjustment Bracket (16) through
the Bench Frame (10) as shown and engage the
Knob into the Bracket.
Lubricate an M10 x 168mm Button Bolt (72) with
the included grease. Attach the Backrest Frames
(18) to the Bench Frame (10) with the Bolt, two
M10 Washers (65), and an M10 Nylon Locknut
(83).
Do not overtighten the Locknut; the
Backrest Frames must be able to pivot easily.
Tighten the four M8 Nylon Locknuts (88) used
in step 13 and the four M6 x 38mm Screws
(73) used in step 14.
13. Orient the two Backrest Frames (18) as shown.
Make sure the indicated holes are closer to
the bottom.
Attach the Backrest Frames to the
Adjustment Bracket (16) with four M8 x 45mm
Bolts (75), four M8 Washers (68), and four M8
Nylon Locknuts (88).
Do not tighten the
Locknuts yet.
12
10
88
88
90
91
12
13
14
15
18
18
68
68
68
68
88
75
75
18
73
92
92
92
92
65
18
83
65
72
Grease
18
16
10
73
41
88
16
Hole
Hole
