10
16. Attach the Seat (40) to the Bench Frame (10)
with two M6 x 16mm Screws (80), an M6 x 64mm
Screw (84), and an M6 Washer (92).
18. Grease an M10 x 82mm Button Bolt (82). Attach
the Leg Lever (13) to the Front Leg (17) with the
Bolt and an M10 Nylon Locknut (83).
Do not
over tighten the Locknut; the Leg Lever must
be able to pivot easily.
19. Slide a Pad Tube (37) into the Leg Lever (13).
Slide two Pads (54) onto the Pad Tube.
Repeat
with the other Pad Tube.
Slide two Pads (54) onto the Front Leg (17).
17. Attach the Leg Lever Bumper (52) to the Leg
Lever (13) with an M4 x 16mm Screw (76).
Make
sure the Bumper is attached as shown in the
inset drawing.
Insert a Leg Lever Pin (48) into the Leg Lever
(13). Attach the Pin to the Leg Lever with an M4 x
9mm Screw (87).
40
80
80
92
84
10
16
17
18
19
52
Longer
edge on
bottom
52
13
87
48
76
13
83
82
17
Grease
37
54
37
17
54
54
13
54
