15
BEEP/FLASH CODE #5 - BRAKE FAULT
This Beep/Flash Code occurs because the park brake release switch is active or the park brake may be faulty.
Check the Park Brake Position
1. Turn the key to the off position.
2. Disengage and then re
-
engage the park brake.
3. Turn the key to the on position. Did the beep code clear?
• Yes?
-
OK.
• No?
-
Go to the next step.
Check Resistance at the Brake.
4. Remove the battery pack.
5. Separate the brake harness (6) and measure resistance (
with the park
brake engaged)
across the two pur ple wir es coming fr om the br ake.
See figure 21.
Refer to the wir ing diagr am on page 11.
• 45 ohms – 52 ohms? – Replace the controller.
Note: If you have replaced the controller and the fault persists,
Figure 21. Connection from Brake
go to step 6 below.
• Out of range? – Replace the complete transaxle/motor/brake
assembly.
• Shorted or open? – Replace the complete transaxle/motor/brake
assembly.
Check Park Brake Resistance at the Controller.
6. Remove the two screws securing the controller.
7. Lift the controller to expose the control board underneath it.
8. Measure continuity across the purple brake harness CN4 and
yellow brake harness CN3.
See figure 23.
Refer to the wiring
diagram on page 11.
• Continuity?
Yes
-
Replace the control board.
No
-
Replace harness(es) as needed.
Figure 22. Connection from Brake
BEEP/FLASH CODE #6 - PADDLE FAULT (OUT OF NEUTRAL)
This Beep/Flash Code means that the throttle control lever was not
in the neutral position when the key is turned to the on position.
1. Turn the key to the off position.
2. Make sure that the paddle pot is not obstructed and it can
return to the neutral (center) position.
3. Move the throttle pot forward and then reverse. Make sure that
it is not obstructed. Does it spring back to the neutral position?
• Yes? – Go to the next step.
• No? – Check for obstructions. Adjust if necessary. Replace if
the adjustment does not work or if there are no obstructions.
4. Turn the key to the on position. Does the code return?
• No? – OK
• Yes? – Go to Beep CODE #7 to test the paddle pot.
Figure 23. Control Board
CN3 CN4
Summary of Contents for Buzzaround Carry On
Page 2: ...2 ...
