18
BUZZAROUND CARRY ON REPLACEMENT INSTRUCTIONS
DRIVEWHEEL REPLACEMENT
Tools needed: 5mm Allen wrench, small straight screwdriver.
1. Place the freewheel lever into the engaged position.
2. Remove the key from the key switch.
3. Place the rear of the scooter onto blocks.
4. Remove the center cap.
5. Remove the bolt and washer that fasten the wheel to the axle.
Make sure you retain the axle key.
See figure 31.
6. Place a new wheel onto the axle.
Make sure that the
axle key is reinstalled in its original position.
7. Reinstall the hardware removed in step 5 and tighten securely.
8. Reinstall the center cap.
ANTI TIP REPLACEMENT
Tools needed: 13mm Socket, Phillips screwdriver.
1. Place the freewheel switch in the engaged position.
2. Remove the key from the key switch.
3. Remove the seat.
4. Remove the battery pack.
5. Stand the scooter up as shown.
See figure 32.
Tip Hazard! Make sure the scooter is
stable before attempting any repairs.
6. Remove the left or right anti tip assembly, by
removing the (1) lock nut and (1) Phillips screw shown
inside the small circles.
See figure 32.
7. Install the new anti tip assembly by reversing
steps 1
-
6.
Note: If needed, repeat step 6 for the opposite side.
THROTTLE POT REPLACEMENT
Tools needed: Phillips screwdrivers, 7mm socket
1. Place the freewheel lever in the engaged position.
2. Remove the key from the key switch.
3. Remove the battery pack from the scooter.
4. Separate the upper and lower dash halves by removing the (7)
Phillips screws.
See figure 33. Refer to figure 37 on page 21.
5. Unplug the throttle pot (8) harness from (CN7) on the console board.
6. Remove the (2) nut and bolts that fasten the throttle pot assembly.
7. Reverse steps 1
-
6 to reassemble.
Figure 31. Drive Wheel Axle Key
Figure 33. Throttle Pot
Figure 32. Anti Tip Assemblies
Summary of Contents for Buzzaround Carry On
Page 2: ...2 ...
