![background image](http://html1.mh-extra.com/html/goldair/gbqa420/gbqa420_operating-instructions-manual_2240106003.webp)
GAS LEAK TESTING
It is important that you leak test the BBQ before first use and
every time the gas
cylinder is refilled and reconnected to the BBQ.
To complete a Leak Test:
•
Make sure all the control knobs are OFF.
•
In a small container, mix up a solution of water and detergent/soap.
Mix the solution well (about the same concentration as washing up water).
•
Turn the cylinder ON by rotating the knob to the open position.
•
Using a brush or spray bottle apply the soap solution to the gas line and each
join in the gas line including:
•
The gas connection at the inlet of the BBQ
•
All gas hose connections
•
The gas connection at the gas cylinder
•
If bubbles appear, there is a gas leak.
•
If the leak is at the connection, re-tighten and re-seal.
•
If the leak is anywhere else or you cannot resolve the leak by tightening the
connection DO NOT PROCEED.
•
Replace gas hose and regulator.
•
Replacement hose and regulators can be purchased from your local BBQ
retail specialist
Read Me First
Page 2
Summary of Contents for GBQA420
