Goldacres GA4908090, Operator'S & Parts Manual

Page: 24 / 80

24
1. Operate the starter:
RECOIL STARTER
• Pull the starter grip lightly until you feel
resistance, then pull briskly in the direction
of the arrow as shown below. Return the
starter grip gently.
NOTE: Do not allow the starter grip to snap
back against the engine. Return it gently to
prevent damage to the starter.
ELECTRIC STARTER
• Turn the key to the START position, and
hold it there until the engine starts.
• When it starts, release the key, allowing it to
return to the ON position.
NOTE: Using the starter for longer than 5
seconds at a time will overheat the motor and
can damage it. This type of overheating is not
covered under warranty. If the engine fails to
start within 5 seconds, release the key, and
wait at least 10 seconds before trying the
starter again.
2. If the choke lever was moved to the
CLOSED position to start the engine,
gradually move it to the OPEN position as
the engine warms up.
Setting Engine Speed
Move the throttle lever to somewhere between
the MAX. and MIN. position to set desired
engine speed.
IMPORTANT: The reduction gearbox operates
at a 6:1 ratio from the engine to the pump.
The spray pump speed should not exceed
540 RPM. Therefore the engine should not be
allowed to run over 3250 RPM.
ENGLISH
5
3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
4. Turn the engine switch to the ON position.
5. Operate the starter.
RECOIL STARTER:
Pull the starter grip lightly until you feel resistance, then pull
briskly in the direction of the arrow as shown below. Return the
starter grip gently.
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
ELECTRIC STARTER (applicable types):
Turn the key to the START position,
and hold it there until the engine
starts.
If the engine fails to start within 5
seconds, release the key, and wait at
least 10 seconds before operating the
starter again.
Using the electric starter for more
than 5 seconds at a time will overheat
the starter motor and can damage it.
This type of overheating is not
covered under warranty.
When the engine starts, release the
key, allowing it to return to the ON
position.
6. If the choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as the
engine warms up.
THROTTLE LEVER
MAX.
MIN.
1/3 POSITION
MIN.
EXCEPT ELECTRIC
STARTER TYPES ELECTRIC STARTER TYPES
ON
ENGINE SWITCH
ON
ENGINE SWITCH
ON
ON
STARTER GRIP
Direction to pull
START
START
ENGINE SWITCH
(applicable types)
OPEN
CHOKE LEVER
CLOSED
OPEN
37Z4V6100.fm ページ ２０１８年１０月４日 木曜日 午後１時５４分
ENGLISH
5
3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
4. Turn the engine switch to the ON position.
5. Operate the starter.
RECOIL STARTER:
Pull the starter grip lightly until you feel resistance, then pull
briskly in the direction of the arrow as shown below. Return the
starter grip gently.
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
ELECTRIC STARTER (applicable types):
Turn the key to the START position,
and hold it there until the engine
starts.
If the engine fails to start within 5
seconds, release the key, and wait at
least 10 seconds before operating the
starter again.
Using the electric starter for more
than 5 seconds at a time will overheat
the starter motor and can damage it.
This type of overheating is not
covered under warranty.
When the engine starts, release the
key, allowing it to return to the ON
position.
6. If the choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as the
engine warms up.
THROTTLE LEVER
MAX.
MIN.
1/3 POSITION
MIN.
EXCEPT ELECTRIC
STARTER TYPES ELECTRIC STARTER TYPES
ON
ENGINE SWITCH
ON
ENGINE SWITCH
ON
ON
STARTER GRIP
Direction to pull
START
START
ENGINE SWITCH
(applicable types)
OPEN
CHOKE LEVER
CLOSED
OPEN
37Z4V6100.fm ページ ２０１８年１０月４日 木曜日 午後１時５４分
ENGLISH
5
3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
4. Turn the engine switch to the ON position.
5. Operate the starter.
RECOIL STARTER:
Pull the starter grip lightly until you feel resistance, then pull
briskly in the direction of the arrow as shown below. Return the
starter grip gently.
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
ELECTRIC STARTER (applicable types):
Turn the key to the START position,
and hold it there until the engine
starts.
If the engine fails to start within 5
seconds, release the key, and wait at
least 10 seconds before operating the
starter again.
Using the electric starter for more
than 5 seconds at a time will overheat
the starter motor and can damage it.
This type of overheating is not
covered under warranty.
When the engine starts, release the
key, allowing it to return to the ON
position.
6. If the choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as the
engine warms up.
THROTTLE LEVER
MAX.
MIN.
1/3 POSITION
MIN.
EXCEPT ELECTRIC
STARTER TYPES ELECTRIC STARTER TYPES
ON
ENGINE SWITCH
ON
ENGINE SWITCH
ON
ON
STARTER GRIP
Direction to pull
START
START
ENGINE SWITCH
(applicable types)
OPEN
CHOKE LEVER
CLOSED
OPEN
37Z4V6100.fm ページ ２０１８年１０月４日 木曜日 午後１時５４分
6
ENGLISH
STOPPING THE ENGINE
To stop the engine in an emergency, simply turn the engine switch
to the OFF position. Under normal conditions, use the following
procedure. Refer to the instructions provided by the equipment
manufacturer.
1. Move the throttle lever to the MIN. position.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here.
2. Turn the engine switch to the OFF position.
3. Move the fuel valve lever to the OFF position.
SETTING ENGINE SPEED
Position the throttle lever for the desired engine speed.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipment manufacturer.
For engine speed recommendations, refer to the instructions
provided with the equipment powered by this engine.
THROTTLE LEVER
MIN.
MIN.
EXCEPT ELECTRIC
STARTER TYPES ELECTRIC STARTER TYPES
OFF
ENGINE SWITCH
OFF
OFF
ENGINE
SWITCH
OFF
FUEL VALVE
LEVER
OFF
OFF
ON
THROTTLE LEVER
MAX. MIN.
MIN.
MAX.
37Z4V6100.fm 6 ページ ２０１８年１０月４日 木曜日 午後１時５４分
MAX. 3250 RPM