42
Connecting to a power
source
The following steps should be followed when
connecting to a power source:
1 Ensure that the battery is 12V DC and that
a 40amp, circuit breaker is fitted to the
positive lead at the battery.
2. Using the Anderson plug supplied,
connect the red connector to the positive
(+) terminal and the black connector to the
negative (-) terminal. It is recommended to
get an electrician to wire this unit.
WARNING:
Do not use the nominally 1.5V
Lithium cells in the remote unit as these
are in fact above 1.8V when new, and may
result in damage to the remote unit. Use
only high quality 1.5V alkaline cells for good
performance and product reliability.
Connecting to a water
source
The following steps should be followed when
connecting to a water source:
1 The ½” supply hose must have a pressure
rating that exceeds the pump pressure,
needs to be connected up to the hose reel.
2. Slide the supplied nut onto the hose, then
slide the olive on so there is about 4-5mm
of hose coming through the olive.
3. Fit the hose and tighten the nut to the Pro-
Reel.
Connecting the Engine
Remote Shutdown
WARNING:
Do not have any power connected
for this operation.
1. Disconnect the 6 pin plug from the control
box.
2. Open the female plug that is on the electric
motor side. Remove the seal from the “E”
port
3. With a 3mm blue wire, fit the supplied
green seal and crimp on the terminal pin.
4. Fit wire into the “E” port on the 6 pin plug
and press home until you feel a click. The
pin is seated. Close the cover on the plug.
5. Fit the two plugs together and ensure they
seat correctly.
6. Feed the blue wire to the pump motor ON
switch making sure that it is out of the way
of moving parts and will not get hot from
any parts of the engine.
7. Fit the wire to the earth wire on the engine
ON/OFF switch.
Prepare for use
1. Inspect the unit to ensure there is no
damage or wear which could lead to injury,
further damage or reduce its performance.
2. Check all hoses and fittings, including
spray gun, for leaks or damage.
3. Check all bolts and nuts to make sure they
are tight and secure.
4. The Pro-Reel hose reel is operated by
remote control and when fitted should be
in a location which is easily accessible
with clearance between the reel and all
other items.
PROREEL CABLE SIZE CHART @ 12vdc / 30 amps
30 amp overload protection
Distance from battery to Anderson plug (mts)
1
2
5
7.5
10
Cable in mm
x2
2.5
6
16
25
25
AWG
13
10
6
4
3
