32
5-6. Ribbon Tension Adjustment
Due to differences in the ribbon material, if ribbon
wrinkles occur during printing, please adjust the ribbon
expansion by turning the ribbon shaft clockwise to
increase the expansion.
If a narrower ribbon is being used (especially ribbon
width less than 2”), and printer might have problem
pulling the labels. This time, please adjust the ribbon
expansion by turning the ribbon shaft counterclockwise
to decrease the expansion.
5-7. Cutter
1. There are two holes (as marked “A”)on the sides of
the cutter
2. When paper jams and cutter malfunctions, power
off the printer. Use 3mm hexagon screwdriver to
turn the cutter blade clockwise.
3. After the paper jam is cleared, power on the printer,
and the cutter blade will go back to its original
position.
Note: The label / paper used for cutting is suggested
t
o be least 30mm in height.
