18
7. After the Rewinder is installed, plug the
Rewinder Cable Connector onto the
Rewinder Connector.
8. Install the media into the printer (see
2-1.
Ribbon Installation
and
2-3. Label
Installation
)
9. Peel off a few labels from the liner (about
400mm of liner), then feed the liner
through the Printer Mechanism and around
the Label Feed Guide.
10. Wrap the liner around the Liner Rewinder
Shaft, and use the U Shape Clip to secure
the liner.
Note: make sure the liner rewind direction.
11. Screw the Bottom Front Cover back onto
the printer.
12. Press lower part of the Stripper Sensor to
flip it open.
13. Flip the Stripper Sensor to the sensor
detect position, then close the Top Cover.
14. When the liner rewinds to about 110mm in
diameter, the liner roll will touch the Max.
Liner Rewind Sensor and the printer will
stop printing until liner has been removed
from the printer.
Note1: make sure the printer is set to have the
stripper function on.
Note2:The label / paper used for rewinding
purposes is suggested to be at least
30mm in height, and 100mm at the most.
