22
EZ2200 : V1.000
Serial port : 96,N,8,1
1 DRAM installed
Image buffer size : 1050K
000 FORM(S) IN MEMEMORY
000 GRAPHIC(S) IN MEMORY
000 FONT(S) IN MEMORY
000 ASIAN FONT(S) IN MEMORY
998K BYTES FREE MEMORY
^S6 ^H5 ^R000 ~R200
^W100 ^Q102,3
Option : ^D0 ^O0 ^AT
Gap Sensor AD : 97 142 188
Model & Version
Serial port setup
Test pattern
Number of DRAM installed
Image buffer size
Number of forms
Number of graphics
Number of fonts
Number of asian fonts
Free memory size
Speed, Density, Ref. Point,
Print direction
Label width, Form length
Cutter, Stripper, Mode
Gap sensor AD
4-3. Self-Test
The Self-Test function in a printer will help the user to troubleshoot whether the printer is operating normally. In
the Self-Test Mode, the printer will print out a test sample each time when the Feed key is pressed. To stop the
Self-Test procedure in the middle, simply power off the printer. Below is the Self-Test procedures:
1. Power off the printer, press and hold the Feed key.
2. Power on the printer (while still holding the Feed key), release the Feed key after hearing 3 beeps.
After about 1 second, printer would automatically print out the following, and the LCD Display would show “Self
Test.” This means the printer is operating normally.
Self-Test includes the internal printer data setting.
4-4. Dump Mode
When label setting and the print result don’t match, it’s recommended to go into the Dump Mode to check
whether there’s a mistake in data transmission between the printer and the PC. For example, when printer
receives 8 commands, yet without processing these commands, only printed out the contents of the commands,
this will confirm whether the commands were received correctly. Test procedures to enter the Dump Mode is
as follows:
1. Power off the printer, press and hold the Feed key.
2. Power on the printer (while still holding the Feed key).
3. When LCD Display shows “DUMP MODE BEGIN,” release the Feed key. Printer will automatically print
“DUMP MODE BEGIN.” This means the printer is already in Dump Mode.
4. Send commands to the printer, and check to see if the print result matches the commands sent.
【
NOTE
】
: to cancel (get out of the Dump Mode), press the Feed key, this time printer will automatcially print
out “OUT OF DUMP MODE.” This indicates that printer is back in the standby mode. Or power off to exit the
Dump Mode.
