Godex DT200 Series, User Manual

Page: 4 / 55

SAFETY INSTRUCTIONS
Please read the following instructions carefully.
1. Keep the equipment away from humidity.
2. Before you connect the equipment to the power outlet, please check the voltage of the power
source.
3. Make sure the printer is off before plugging the power connector into the power jack.
4. It is recommended that you connect the printer to a surge protector to prevent possible transient
overvoltage damage.
5. Be careful not to get liquid on the equipment to avoid electrical shock.
6. For safety and warranty reasons, ONLY qualified service personnel should open the equipment.
7. Do not repair or adjust energized equipment under any circumstances.
8. Before disassemble the cutter, please turn off the power and wear the gloves on.
Hot parts!
Burned fingers when handling the parts
Wait one-half hour after switching off before handling parts.
The blade is sharp, please do not touch.
Do not remove the ground pin of power cord. Grounding is an important safety
feature. Please keep the power cord grounded all the time
*Caution*
⚫
Danger of explosion if battery is incorrectly replaced. Replace only with the equivalent type
recommended by the manufacturer.
⚫
Dispose of used batteries according to the manufacturer ’ s instructions.
⚫
Only use with designated power supply adapter model.
⚫
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Specifications are subject to change without notice.